Archives: Answers

If you are still feeling the sting keep investigating. If the pool wasn’t built properly (and it sounds like perhaps it was not) you may need to remove patio to make sure all grounding/bonding are in place and add if Read More …

Yes, the process would be similar on a Hayward heater – the connections and internals are just arranged differently and you’d have to build a specific set up to accomplish that.

If a pool isn’t running properly on backwash or rinse there could be issues with the multiport valve, or a blockage of the main drain or skimmer. If it filters properly then the issue is most likely in a mulitport Read More …

A pool should be full of water whenever possible. We’ve found that the issues you are experiencing with paint are pretty common. It’s very difficult to avoid roller tracks and matching paint is almost impossible if it’s done over several Read More …

We don’t move a heater to descale it. We just loosen the unions connecting to the heater and run the water through an isolated heater. It’s a bit of work and you need the right set up fittings but it Read More …

You could try to add a layer of tile, that will only add the thickness of the tile though, so it many not be much of a noticeable difference.

You can’t put tru-tile over an existing liner. You can however remove the liner, add the tru-tile track, and order a new liner with the specific truTile bead on it. We have converted a vinyl liner pool into a trutile Read More …

If you have water loss painting isn’t likely to remedy the situation. When the pool is acid washed it takes a layer off the surface, so if you do have leaks it will likely get worse. Some more troubleshooting is Read More …