Archives: Answers

Verify power at the panel, and that the on switch is on inside the heater. Then investigate any critters that could have nested in the heater or chewed wires and start using a voltage meter to determine where the power Read More …

The only turbo clean system I can find online is a robotic pool cleaner, not one that would have a pump that I can see. Please post a new question with a link to the product you have? If it’s Read More …

If the dolphin gets stuck in spots or if you have extreme loss of the ecoFinish it’s likely an installation issue. Properly applied ecoFinish shouldn’t rub off of the pool surface. It’s both chemically and mechanically bonded to the pool Read More …

If it were us, we would suggest replacing the heater and making sure the gas line and run are sized properly. When in doubt, reduce the gas heater size and it’ll likely improve the heater function. a 406 is pretty Read More …

The stem of a multiport valve does come apart but it is very difficult to put back together properly. You can attempt it, but if it doesn’t reseat properly, please be ready to replace the valve which may be your Read More …

Did you check your flow first? Make sure the filter isn’t in need of service, and nothing is stuck in the impeller of the pump etc. – and if the issue persists yes, swap out the cell. If the new Read More …

You can often use a surface mount coping and mount under the aluminum to the top of the wall if you are doing a liner renovation. Or, if it’s time for some patio renovation as well, replacing the coping with Read More …

ecoFinish is more forgiving to water chemistry than other types of pool finish so you will likely experience less issues. Keep in mind if you balance the pool before you close though the change in water temperature will affect the Read More …