Archives: Answers

Here’s a more detailed breakdown: Flashing “Inspect Cell” light: This means you should remove the cell, clean it, and check for any calcium deposits or buildup.  Salt level: If the “Check Salt” light is also flashing, it likely means your Read More …

Yes, if your stabilizer is that high, continue using unstabilized chlorine. Or, if you want to adjust the stabilizer level down, remove some water and replace with fresh until you get the stabilizer level back down to an acceptable threshold Read More …

It’s not likely the nozzle size will help – but the positioning of the jets themselves.  Make sure water chemistry is spot on, and the best option at this point may be to remediate any build up you do experience. Read More …

The IntelliFlo pump, specifically the Variable Speed and Flow (VSF) model, features a “Loc Mode” or “Lock Mode” function. This mode allows you to lock in a specific speed or flow rate setting, preventing accidental changes to the pump’s operation.  Read More …

Verify power at the panel, and that the on switch is on inside the heater. Then investigate any critters that could have nested in the heater or chewed wires and start using a voltage meter to determine where the power Read More …

The only turbo clean system I can find online is a robotic pool cleaner, not one that would have a pump that I can see. Please post a new question with a link to the product you have? If it’s Read More …

If the dolphin gets stuck in spots or if you have extreme loss of the ecoFinish it’s likely an installation issue. Properly applied ecoFinish shouldn’t rub off of the pool surface. It’s both chemically and mechanically bonded to the pool Read More …

If it were us, we would suggest replacing the heater and making sure the gas line and run are sized properly. When in doubt, reduce the gas heater size and it’ll likely improve the heater function. a 406 is pretty Read More …